ENERGY
Our Product
Our solutions (devices) are next generation power quality products that decrease the electrical demand, total electrical power generation (KVA), and carbon footprint without replacing inefficient electrical and mechanical equipment in buildings. They are already operational in 28 countries.
The Science
Our product is a unique and innovative industry changing technology. The device precisely senses the supply input and demand output, matches the impedance parameters, adjusts the resonance of the resulting network loop, synchronizes and optimizes the output.
This occurs at very high speeds in the device eliminating nearly all the wasted electrical power in the system. This reduces total electrical consumption by significant levels and enhances electrical efficiency of the network to near unity.
Maximum power transfer theorem (Jacob’s Law – 1840) focuses on increasing total electrical efficiency by decreasing losses using impedance matching.
Benefits
Decrease Current and electrical Demand (20 to 40%) of inductive loads
Avoids Overload conditions and hot spots in panels and equipment. Decreases I2R losses, KVAr, Harmonics
Extend life of connected inductive equipment (20%) – Delay aging or replacement of mechanical equipment
Reduce service, repair and maintenance cost (25%) for inductive loads
Protect investment in connected equipment
Save money on utility bills based on utility tariffs
Application
•Commercial Office buildings
•Hospitals and Clinics
•Data Centers
•Industrial Plants and Factories – Manufacturing
•Warehouses and Distribution Centers
•Water Filtration Plants – Pumps, and Motors
•Retail Outlets
•Education – School Buildings
•Pumping Stations
Features
•Reduces system harmonics – load and power grid
•Reduces carbon footprint and greenhouse
•Reduces wasted electrical power, decreasing total current required to operate equipment
•Our device is a solution for balanced or unbalanced loads
•Its an electronic solution, consumes less than one ampere of current for every 100 amps/480v/3 phase
•It does not add capacitance into network
•Our device releases capacity due to reduced current and runs the network cooler.
•It does not require programming, as it is self programming upon commissioning.
•Except for ventilating fans there are no moving parts in our device
•Our device performs with the same efficiency and effectiveness from 20% to 100% utilization of its rated capacity.
•It’s a fail-safe technology , does not interrupt power to facilities equipment when it is either on or off.
•As a consequence of above attributes, our device improves and maintains a power factor of greater than 95%.
Lowering Energy Costs
Information required from you
We can provide you an estimated savings of current consumption & other parameters once our device is installed on the inductive loads.
In order to provide an estimate for a given building/factory we request you to kindly arrange for a one line diagram for 415 Volts, 3 phase electrical network connected to inductive loads such as Chillers, AHU's, RTU's, Elevators, Water pumps, Motors, etc.
In addition, we also require the following of the target load / panel:
1) Full Load Amps (FLA)
2) Rated running Load Amps (RLA)
3) Existing Power Factor at the load / panel (Cos Ø ) over a period of time.
4) Existing Power Factor at the building entrance ( Cos Ø )
5) Actual Current at the building entrance.
Also, do provide the average monthly current consumption for the factory along with the average electricity bills to enable us to provide you an estimated cost avoidance savings.
So, lets be your energy saving partner….as every coin counts!